What causes elephant foot?

It’s usually a mix of settings (flow/retraction/speed), temperature, and mechanical factors. Start with calibration tools, then verify hardware basics.

How do I fix elephant foot fast?

Apply the top fixes in order and re-test after each change. Use the linked PrintFix Pro tools to dial in flow, temperature, and motion settings.

Should I change multiple settings at once?

No — adjust one variable at a time so you can see what actually improved the print.

3D Print Defect Fix • Step-by-step

Fix Elephant Foot

First layer squish causing flared bottoms and poor fit.

Run Diagnose Open Tools Fix My Print Hub

Quick Fix Checklist

Identify the symptom and confirm it with a simple test.
Apply the top fixes below one at a time.
Use the linked tools to dial-in settings.
Re-test and lock the result into your slicer profile.

Top Fixes for Elephant Foot

Calibrate flow/extrusion (EM/flow rate) before chasing smaller tweaks.
Verify temperature (too hot = strings/blobs, too cold = weak flow/adhesion).
Reduce speed/acceleration on detail-heavy parts; stabilize mechanics.
Improve cooling/bridging and travel behavior (retraction + wipe/coast where appropriate).
Check filament condition (wet filament causes inconsistent extrusion + surface artifacts).

Recommended PrintFix Pro Tools

Elephant Foot Fix Tool
Bed Level Gap
Bed Temp Helper

Related Guides

Fix 3D Prints (Complete Guide)
3D Printing Calculators
Slicer Cheat Sheets